Airbrushes have an odd mystique about them. Some people say “that’s not fair, he cheated and used an airbrush!” Some people try to use them as the sole method of painting. But an airbrush is just a tool, and it can only really speed up something that you were trying to do anyway. He painted a solid base/shade/highlight in about 10 minutes, which took us 3-4 hours to get done right. They have a steep learning curve. Be prepared to swear for at least 2 months.
Just about every airbrush brand has a good model, so don’t worry so much about that. Except for Testors/Aztek, which apparently have some technical flaws to them. You want a dual-action airbrush, so you can control airflow through the brush. You want a top/gravity-fed airbrush so you can use less paint. Side-feed are ok too, but with siphon/bottom-fed you have to mix a lot of paint in order to get the little hose to be able to suck on the paint. You want a brush that can have a nozzle somewhere between 0.15 and 0.6 size. 0.4 or lower is preferred for our uses.
Compressors should put out 15-30psi and have a regulator so you can control the amount of air coming from it. You can use a cheaper power tool compressor, but you’ll have to buy an adapter and a regulator and probably an extra water trap since they put out a lot of heat. One with a tank is nice since it only has to run when the tank depressurizes. Otherwise the compressor is only good for about 45 minutes before it overheats. His cost $1500!
A few accessories of note:
- A quick connect adapter means you can detach the airbrush pretty easily for cleaning or changing paints.
- An airbrush holder lets you put the brush down for a moment.
- A cleaning kit.
He took apart his airbrush for cleaning. Remove the back, pull the needle out without bending it. Remove the front and the nozzle. Use rubbing alcohol and a Q-tip to clean everything and inside the metal casing of the brush. The nozzle can get clogged, so there is a tiny little accessory to poke out the clog. When done painting, put thinner in the bowl and spray it until clean. Brush out the bowl and do it again. Then it’s ready for the next colour.
You can buy airbrush specific paint, but GW/P3 paints work out ok if you thin properly. It can clog the nozzle, so watch out. He creates a thinner that is 85% water and 15% isopropyl alcohol. Mix that 1 part paint to 5 parts thinner.
Then use the same techniques as painting with a brush – use a succession of thin layers. He painted on a base colour, then shaded to black, then highlighted to white. Mask off areas you don’t want covered with paint, let it dry before the next coat and spray away from the tape in case it isn’t stuck down completely.
Just before we finished he passed the model around and someone commented that his base colour was almost gone. He agreed and then thinned out some of the base colour and sprayed it all cover the work he’d just finished, creating a pre-blended piece of work that looked great!
