Work-in-progress

Slightly delayed posting…building the plaguebearer portal.

Found some photos in my upload folder…turns out these are a few steps back in my plaguebearer work.

You’ll have noticed last post that I own a Dremel. I originally bought it so that I could cut up plasticard and MDF board easily, and that’s how I used it on this project.

IMAG0585

The portal is just two pieces of fairly thick plasticard.

To give the vertical piece some stability and strength, I pinned it three times across it’s length. I glued the base to 2 pieces of 50mm bases, which is how many plaguebearers it is supposed to represent.

IMAG0586
IMAG0584

This part was scary. I mean…I have a lot of bloodletter models kicking around my bitz box, but if this hadn’t worked I wasn’t certain what else I would do to get the effect properly! I used an old GW hand saw down the center of this model to split it into two.

Glue both sides of the model appropriately on either side of the portal, and you have one model entering and exiting from a portal!

IMAG0587

IMAG0588

 

I’ll have some more photos of these guys…finished…in a day or two!

You Might Also Like

No Comments

    Leave a Reply