Work-in-progress

Ork Battlewagon 2

This part was less heartbreaking, and more difficult – how to fit the GW add-on kit deffrolla onto the Rhino. The deffrolla fits perfectly onto the stock cab of the battlewagon…no attachment points on the Rhino!

When I started out, I was fiddling around with placement, and I found a spot that looked like it was almost as if GW had intended on the deffrolla being attached to a Rhino in this way. The spots where I glued it – if the Rhino had been a quarter inch higher on the trukk bed, and the deffrolla been a quarter inch thinner, it would have been absolutely perfect.

As it was, I had to shim. Cut a door in half and stick it under the rolla attachment points. Cut up some sprue and glue it beside the attachment to add extra stability.

Added an Ork glyph or two to each side door, and voila! It’s done.

I will be adding on extra grots and orks and things later. I learned that lesson from the last trukk I assembled – don’t glue things inside until you have them painted, or they will look like ass!

Painting

I read this GW article on painting a battlewagon. Pretty good, with some good tips on rusting/corrosion. I have a different paint scheme in mind, but that article will be sitting in a Firefox tab for the next few weeks.

The Rhino will be my standard Regal Blue, with Space Marine Blue highlights. Not certain what other colours to use, but I think I’ll be using the technique mentioned in that article on some darker grays or reds.

You Might Also Like

No Comments

    Leave a Reply